Weeks

Home Hardware

Brush it, roll it, and slip no more. Excel Anti-Slip is a waterborne, acrylic based, non-cementitious, slip resistant coating in a brush or roller applied formulation that, when fully cured, is hard and tough yet flexible. It comes as a neutral base, tintable by adding the desired colour of exterior gloss, semi-gloss, satin acrylic latex, acrylic floor enamel or industrial acrylic enamel paint.

• Is a waterborne, acrylic based, quartz, non- cementitious, anti-slip coating in a brush and roll down formulation
• It is environmently safe, non-flammable and non- hazardous
• Is neutral in colour
• Any decorative colour is available by adding the desired colour of exterior gloss, semi-gloss, satin acrylic latex, acrylic floor enamel or industrial acrylic enamel paint (on a ratio of 1 litre/946ml to 3.4kg pail or 3.78L to a 17kg paint)
• Simply mix thoroughly when adding paint
• When fully cured, it is hard and tough yet flexible
• On horizontal surfaces its Anti-Slip on vertical surfaces it provides a heavy duty textured finish
• It is weather resistant, impact resistant, salts and chlorine resistant when fully cured
• May be cleaned up with water and after application, before it has dried

ADVANTAGES:

• Versatile - anti-slip, protective, decorative
• Weather resistant, tough and flexible
• Easy to use - unlimited colour selection
• Indoor and outdoor; walkways, patios, stairs, pools, decks, balconies and carports
• Waterborne acrylic, non-flammable and environmentally safe
• Machine shop, garage and workshop floors

PREPARATION:

• Remove dust, dirt and debris using stiff brush or broom
• Concrete surfaces must be clean and dry before applying
• For best performance smooth concrete surface may require acid etching before sealing
• Bare metal surfaces require priming with appropriate primer
• All non-metal surfaces must be primed with Excel Acrylic Waterproofer before application
• Allow sealer to dry for 2-4 hours before applying
• Fill all cracks using a high quality, concrete patch mix
• Allow to set/cure according to manufacturers instructions

APPLICATION:

• Add the desired colour of preferred paint to the selected unit of Anti-Slip
• Mix well with a mechanical mixer or on a shaker
• Will take on the same colour of the paint used
• The roller must be a synthetic or mohair type with no more than 3/16" nap
• May also be applied by brush using a high quality polyester/nylon or nylon/bristle type only

COVERAGE:

• Square foot coverage will vary depending on substrate and thickness applied
• Anti-slip with paint added will cover approx. 150 sq. ft. per 3.4kg or 750 sq.ft. per 5 gallon at 20MIL (wet film thickness)